Connecting The Pneumatic System En; Putting Out Of Operation - Abicor Binzel RS-LCi Instructivo De Servicio

7 Operation
6.11 Connecting the pneumatic system
For the supply line, a compressed air hose with an inner width of min.
to the support by means of a screw connection (not included in the scope of delivery). A shut-off valve in the
supply line is advantageous. This allows the BRS-LCi to be quickly and simply depressurized in order to carry
out any installation and maintenance work.
Compressed air of motor
S3 D8/d6
M
D8/d6
Y2
Y2
4 2
14
5 3
Connecting the pneumatic system
Fig. 13
7 Operation
NOTE
• As the cleaning station BRS-LCi is integrated into a welding system, the operating instructions of the
• Make sure that the BRS-LCi is operated with a front sheet only.
1 Switch on the robot control.
2 Start the welding process.
3 Stop the welding process.

8 Putting out of operation

NOTE
• As the cleaning station BRS-LCi is integrated into a welding system, putting out of operation depends
1 Switch off the robot control.
EN - 16
Clamping cylinder
Lifting cylinder
slove stretch above
down
Z2 S2 Z1 S1
D6/d4 D6/d4 D6/d4
Y1
Y1
4 2
14
12
12
5 3
1
1
welding components, such as welding torch and robot control, must be observed during operation.
on the robot control. Please make sure that the shutdown procedures for all components mounted in
the welding system are strictly observed.
ø
6mm is necessary which is fastened
Compressed air of motor
S3 D8/d6
D8/d6
M
S4
D8/d6
E
D6/d4
V
P
D6/d4
D6/d4
Y3
Y3 Y4
4 2
14
12
5 3
1
6 bar
BRS-LCi
D6/d4
Sucks from the
cylinder