ESAB Eye-Tech 9-13 Manual De Instrucciones página 18

H
Changing inside cover lens – lift lens
with finger nail and then slide it out of
the guideways
I
Diopter lenses
Snap the two bolts of the diopter holder
into the two holes on both sides of the
cartridge.
J
Use the eccentric knob
to adjust the mask inclination after it has
been pulled down.
K
Loosen the locking knobs and adjust
eye distance. Settings should be the
same on both sides, with no tilting.
Tighten locking knobs.
L
Headband adjustment
Set upper adjustable band in a trial posi-
tion (as low as possible)
M
Depress ratchet knob and turn until
headband sits firmly but not too tightly.
N
Sweat band
replaceable and washable
O
Potentiometer knob
for setting shade level. (Recommended
shades – see shade table.)
P
Off delay knob
to adjust switching time from
dark to light.
Q
To remove sensor bar
pitch the bar downwards and pull it out.
R
Changing the shade cartridge
Pull potentiometer knob (position to
level 9), then push shade cartridge
outwards from the upper inside rim -
insert in reverse sequence