Stiga Cruiser 430 Li 80 Serie Manual De Instrucciones página 97

5. The motor shuts down
whilst working.
6. The motor stops while
working and the machine
alarm buzzer is trigge-
red (type "I" handle).
7. The display shows
ER3 (Fig.35.B) (type
"II" handle - Advan-
ced Series).
8. The display alterna-
tively shows: ER1
+ OPC (Fig.35.B)
(type "II" handle -
Advanced Series).
9. The display shows
ER1 (Fig.35.B) (type
"II" handle - Advan-
ced Series).
10. The display alterna-
tively shows: 100%
+ ER3 (Fig.35.B)
(type "II" handle -
Advanced Series).
11. The display shows
ER2 (Fig.35.B) (type
"II" handle - Advan-
ced Series).
12. The display alternati-
vely shows ER2+ER3
(Fig.35.B) (type "II"
handle - Advan-
ced Series).
Battery is not inserted correctly.
Low battery.
Obstructions that prevent
rotation of the cutting means.
The thermal protection has tripped
due to overheating of the motor.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessively high grass cutting.
• Obstructions that prevent
rotation of the cutting means.
• Too much grass debris accumulated
in the chassis and discharge channel.
The thermal protection has tripped
due to overheating of the motor.
Thermal protection has tripped due to
excessive current absorption caused by:
• Excessively high grass cutting.
• Obstructions that prevent
rotation of the cutting means.
• Too much grass debris accumulated
in the chassis and discharge channel.
Drive motor over current for heavy
working conditions (drive under stress).
Anomaly in the electrical
connection of battery and motor.
Cutting means blocked.
Motor anomaly.
Open the hatch and check that the battery
is fitted in its housing correctly (par. 7.2.4).
Check the battery status and recharge
if necessary (par. 7.2.3).
Remove the safety key, put on your work
gloves and remove any grass remains or
debris from the lower part of the machine
and/or the discharge channel.
Wait for at least 5 minutes and
then restart the machine.
• Set a higher cutting height when the
grass is very tall, then set a lower height
and cut the lawn again (par. 6.4.1).
• Remove the obstructions (par. 7.3.2).
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and
then restart the machine.
Wait for at least 5 minutes and
then restart the machine.
• Set a higher cutting height when the
grass is very tall, then set a lower height
and cut the lawn again (par. 6.4.1).
• Remove the obstructions (par. 7.3.2).
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and
then restart the machine.
– Make sure that the wheels are not
blocked. Clean as needed.
– Check the slope of the land you
are working on (par. 6.4.1).
Remove the safety key and contact
the Technical Assistance Centre for
checks, replacements or repairs.
Turn the machine off, remove the
safety key and wear work gloves.
Check and eventually remove any obstructions
in the machine lower side (par. 7.3.2) that
prevent rotation of the cutting means.
If the problem continues, contact an
authorised Technical Assistance Centre for
checks, replacements or repairs (par. 8.1).
Remove the safety key and contact
the Technical Assistance Centre for
checks, replacements or repairs.
EN - 14