Nacon Asymmetric Manual De Instrucciones página 4

EN /
I Charge the wireless controller
To charge your controller, plug the USB-A connector of the charging cable to one
of the free ports of your PlayStation
to your controller.
The controller LED (10) becomes Yellow, with a breathing effect, if the wireless
controller is OFF. When the controller is ON the LED is White, with a breathing
effect. The breathing effect stops when the battery is fully charged.
- Battery type: Lithium-Polymer
- Battery capacity: 1200mAh
- Playing time: up to 7 hours
- Charging time: up to 6 hours
Note: when you are using the wireless controller, you can check the battery capacity status by pressing
the battery indicator button (16) for more than 1 second.
The LED bar (10) on the front of the wireless controller will light up in one of the
following colours when the Battery Indicator Button (16) is pressed for more than
1 second:
- GREEN: battery level between 75% and 100%
- YELLOW: battery level between 50% and 75%
- ORANGE: battery level between 25% and 50%
- RED: battery level between 10% and 25%
- RED flashing: battery level at less than 10%
To preserve battery life please Power Off your controller after use. To do this
press the 'PS' button until the Player LED turns off. To wake up the controller
press the 'PS' button.
To preserve battery integrity, we recommend that you always re-charge when the
LED is RED or is flashing RED.
I Synchronisation
To synchronise your WIRELESS CONTROLLER with the USB receiver,
follow these steps:
- Ensure that your controller is OFF.
- Press and hold the "SYNC" button of your USB Bluetooth
LED (20) flashes quickly in white.
- Press and hold the PS and SHARE buttons on your wireless controller until the
LED (10) starts to quickly flash in white.
Once the synchronisation is done the LED's, on the USB Bluetooth
wireless controller, will stop flashing.
4 system and plug the micro USB connector
®
receiver until the
®
receiver and
®