Uses; Installation - Sirius SL85 Instrucciones Para La Instalación De Uso Y Mantenimiento

USES

The appliance is already arranged both for
filtering and for suction performances.
* In its filtering version (Fig.1), the air and
fumes conveyed by the appliance are depured
both by a grease filter and by an active coal
filter, and put again into circulation through
the side-grids of the chimney.
For this version an air deflector placed on the
superior part of the pipe and allowing air-
recycling is necessary (Fig.1A).
* In its sucking version (Fig.2), fumes are di-
rectly conveyed outside, through an evacua-
tion duct connected with the superior part of
the wall or the ceiling. Both coal filter and air
deflector are not necessary in this case.

INSTALLATION

Before installing the appliance, make sure
that none of the parts is damaged in any way.
In case of damaged parts, contact your re-
tailer and do not proceed with installation.
Read all of the following instructions with
care before installing the appliance.
- Use an air outlet pipe of the shortest pos-
sible length.
- Limit the number of pipe bends.
- Use a material approved by standards and
regulations.
- Avoid any sudden changes in pipe section
(recommended constant diameter: 150 mm
or equal surface area).
- -The manufacturer shall not respond for air
capacity or noise problems due to non- com-
pliance with above mentioned instructions,
and no warranty shall be given.
ATTENTION: The air outlet of the extrac-
tion motor on all models does not coincide
with the central axis of the cooker hood.
All the models have been designed in order
to have the possibility of directing the air
out-let in the rear side of the appliance; if you
chose to use this function, it is necessary to
remove the no. 10 screws of the sucking unit
support (fig. 3 ), take out the sucking unit and
rotate it in such a way to direct the air out-let
nozzle towards the rear side of the appliance
(fig. 4); then place the sucking unit in its seat
again and tighten the screws previously re-
moved.
For the models SL87 and SLTC87: After re-
moving the extraction unit, rotate the wall
fixing bracket (Des. 3 A) and replace the ex-
traction unit with the air outlet facing towards
the lower part of the product.
By using its drilling template (fig. 5A), drill
the holes for the wall bracket installation;
Appliances shall be installed at a minimum
distance of 650mm from the cook-top.
Drill the remaining holes indicated by the
hole-drilling template.
Fix the brackets to the wall, by using the
screw anchors and screws supplied with the
product; Hang the body (Fig. 6) to the wall
brackets previously fixed.
After the appliance is adjusted, fix it by in-
serting and tightening the safety screws
properly (fig.14).
Sucking version
Using the supplied wall plugs and screws, fix
the tube support bracket (Des. 7) to the wall
and/or the ceiling. The bracket must be fixed
in a central position in respect of the air out-
let flange.
Connect the motor air-outlet flange to the
exhaust hole, by using a suitable pipe. Per-
form the electric connection. Place the two
ornamental pipes on the hood body; lift the
internal pipe up until it reaches the ceiling;
then fix it to the pipe bearing bracket, by us-
ing the two self-threaded screws provided.
9