Installation Steps - LUND 318099 Instrucciones De Instalación

Installation Steps

Locate the existing hole locations shown below. There will be two sets of hole locations (Front, Rear). (Fig. 1 & 2)
Front driver
Fig. 1
1
On some vehicle trim levels, the driver side front inner mounting location may be covered by a plastic panel. To attach the brace,
the front panel can be removed and left off, or the panel can be trimmed to expose the inner mounting location. To trim the panel
Fig. 3
2
NOTE: Actual application may vary slightly from illustrations.
/ El uso real puede variar respecto a las ilustraciones. / L'application réelle peut varier légèrement des illustrations.
cut the area shown below using a pair of tin snips or aviation snips. (Fig. 3 & 4)
Holes utilized
Front inner
location
Page 2 of 4
Rear driver
Fig. 2
Fig. 4