Safety Requirements - EQUATION BH-1401E Instrucciones Legales Y De Seguridad

1. SAFETY REQUIREMENTS

•
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
•
Children of less than 3 years should be kept away unless continuously
supervised.
•
Children aged from 3 years and less than 8 years shall only switch on/o the
appliance provided that it has been placed or installed in its intended normal
operating position and they have been given supervision or instruction
concerning use of the appliance in a safe way and understand the hazards
involved. Children aged from 3 years and less than 8 years shall not plug in,
regulate and clean the appliance or perform user maintenance.
CAUTION - Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and
vulnerable people are present.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly quali ed persons in order to avoid a hazard.
•
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cutout, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and o by the utility.
EN
•
WARNING: In order to avoid overheating, do not cover the
heater.
•
The heater must not be located immediately below a socket-outlet.
•
WARNING: In order to avoid a hazard for very young children, this appliance
should be installed so that the lowest heated rail is at least 600 mm above the
oor.
•
Appliance is to be supplied through a residual current device (RCD) having a
rated residual operating current not exceeding 30 mA.
56
• Means for disconnection having a contact separation in all poles must be
incorporated in the xed wiring in accordance with the wiring rules.
• Regarding the information for the installation and the connection of the
appliance, please refer to the relevant paragraphs below.
• Concerning installation information, please refer to the chapter<<
Installation>> and <<Fixation of the appliance on the wall>>.
• WARNING: In order to avoid a hazard for very young children, this appliance
should be installed so that the lowest heated rail is at least 600 mm above the
oor.
Connect the two conductors of the supply cable to a connection box in respecting the
polarities as below:
- Live: Brown
- Neutral: Blue
Warning: this product shall be installed in the volumes 2 only according the
national wiring rules (For France NF C 15-100).
Note: We suggest that you to contact a professional electrician for assistance.
3. FIXATION OF THE APPLIANCE ON WALL
1. Choose a wall on which there is enough space.
2. Use a Φ6 drill to drill 6 holes according to following positions.
3. Fit the pegs from the accessory bag in these holes.
4. Detach the up-hook from the back of the appliance and put it in the position of the ve pegs
at the bottom. Fix the up-hook on wall with ve ST4X30 screws.
5. Hang the appliance on wall with a ST4X30 screw on the peg above.
6. Tighten four M5X12 screws on the right side and one ST4X12 screw on the left side to x the
appliance.
57
2. INSTALLATION
EN