For Models Without A Factory Amplifier - Metra Electronics Axxess BX-CH34 Instrucciones De Instalación

Attention!
This interface will work with models that are either factory
amplified, or non-amplified. Please follow the instructions carefully for your
model vehicle. Failure to do so will result in either no sound, or low sound.
If you are unsure if your vehicle is factory amplified or not, please contact
your local dealership.

For models without a factory amplifier:

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the (2) Red wires to the accessory wire.
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
connected to hear sound from the factory amplifier.)
• Connect the Orange/White wire to the illumination wire. (If the aftermarket radio
has no illumination wire, tape off and disregard this wire.)
• Tape off and disregard the Brown wire, it will not be used in this application.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Tape off and disregard the Green, Green/Black, Purple, and Purple/Black wires,
they will not be used in this application.
BX-CH34
Connections to be made
The following (3) wires are for multimedia/navigation radios that require these wires.
4
• Connect the Green/Purple wire to the reverse wire (if applicable).
• Connect the Light Green wire to the parking brake wire (if applicable).
• Connect the Blue/Pink wire to the VSS/speed sense wire (if applicable).
From the LD-BX-CH3 OR LD-BX-CH4 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Blue or Blue/White wire to the antenna turn-on wire (if populated
on the factory harness). (The LD-BX-CH4 uses a Blue wire; the LD-BX-CH3
uses a Blue/White wire)
• Disconnect the (2) 4-pin connectors that have Green, Green/Black, Purple,
and Purple/Black wires.
• Connect the 4-pin connector with White, White/Black, Gray, and Gray/Black
wires, to the 4-pin connector with Green, Green/Black, Purple, and Purple/
Black wires on the black 22-pin connector.
• Connect the 4-pin harness with stripped leads to the 4-pin connector with Green,
Green/Black, Purple, and Purple/Black wires on the gray 22-pin connector.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
Continue to 3.5mm jack steering wheel control retention