Bellelli Leonardo Manual De Instrucciones página 18

Components of the child seat (Fig. 1)
Identify the components of the child seat before
using it. Consult figure 1 carefully.
EN
A. seat belt tensioner
B. belt restraint guide
C. metal yoke
D. rear cover
E. belt guide
F. child seat
G. ergonomic insert for newborn babies
H. shoulder pads
I. buckle
J. adjuster
K. recline handle
L. front guides
M. adjuster strap
N. booster lever
O. base
P. metallic yoke for pads
Initial adjustment of the child seat (Fig. 2 - 14)
Identify the group relative to your child:
Weight
0 - 13 kg *
9 - 18 kg *
* From 9 to 13 kg
How to recline the child seat (Fig. 2)
Pull recline handle (K) and simultaneously
move the seat forwards or backwards until
achieving the required inclination (fig. 2).
Warning: After having released the handle,
check that the seat is locked in the new position.
Group
0+
1
If the child is unable to
remain seated unas-
sisted for long periods
do not position the
child seat facing the
direction the car is
traveling in. Follow the
instructions for group
0+.
16
Adjusting the height of the seat belts (Fig. 3 - 4)
Adjust the height of the seat belts before fitting
the child seat in the car.
Group
Place the seat on the ground.
0+ Pull recline
simultaneously pull the child seat
forwards to recline it fully.
Place the child in the seat.
Check that the harness straps
are adjusted so that they are as
close as possible to the child's
shoulders
immediately below the top of the
shoulders (fig. 3).
Group
Place the seat on the ground.
1 Pull recline handle and simulta-
neously push the child seat
backwards so that it assumes the
most upright position.
Place the child in the seat.
Check that the harness straps
are adjusted so that they are as
close as possible to the child's
shoulders
immediately above the top of the
shoulders.
How to change the position of the child seat
harness strap (Fig. 5 - 13)
Remove cover (D) on the rear of the backrest
(fig. 5).
Put the child seat in a completely upright
position.
Press adjuster (J) underneath the seat and
simultaneously pull both harness straps (fig 6).
Disengage one harness strap from the metal yoke
(C) on the rear of the child seat backrest (fig. 7).
Pull out the harness strap through the slot in the
backrest (fig. 8).
Remove the metallic yoke (P) and remove the
shoulder padding strap from the backrest (fig. 9).
Thread the metallic yoke (P) and the strap
through the slot in the backrest at the required
height (fig. 10).
Reattach the strap to the metallic yoke (fig. 11).
Repeat the same steps with the other harness
strap.
Pull the adjuster strap once you have completed
the procedure (fig. 12).
Close cover (D) on the rear of the backrest (fig. 13)
Warning: make sure that the straps pass
through the pad (H) and that the rubbery part is
facing the child's body.
handle and
and preferably
and preferably