BAUKER EURO 6 Manual De Instrucciones página 39

22. DO NOT CLEAN PLASTIC PARTS WITH SOLVENTS
Solvents such as gasoline, thinners, or other substances that contain alcohol can damage
plastic parts, do not rub plastic parts with these substances. If necessary, clean these parts
with a soft cloth dampened with water and soap or suitable liquids.
23. USE ONLY ORIGINAL SPARE PARTS
The use of non-original spare parts invalidates the warranty and causes malfunctions of the
compressor. Original spare parts are available from authorized dealers.
24. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Contact an authorized service center for all repairs.
Unauthorized modification may impair the performance of the compressor and may result in
serious accidents for persons who do not have the necessary technical knowledge to make
modifications to the machine.
25. SWITCH OFF THE PRESSURE SWITCH WHEN THE COMPRESSOR IS NOT IN USE
When the compressor is not running, set the pressure switch button to "0" (OFF), disconnect
the compressor from the power source and open the line tap to discharge compressed air
from the tank.
26. DO NOT TOUCH THE HOT COMPONENTS OF THE COMPRESSOR
To prevent burns, do not touch pipes, engine and other hot parts.
27. DO NOT DIRECT THE AIR STREAM DIRECTLY TOWARDS THE BODY
To prevent hazards, never direct the air stream at people or animals.
28. DRAIN THE CONDENSATE FROM THE TANK
Discharge the tank daily or every 4 hours of operation. Open the drainage device and tilt the
compressor if needed to remove the accumulated water.
29. DO NOT STOP THE COMPRESSOR BY PULLING THE POWER CABLE Use the ON/OFF
switch on the pressure switch to stop the compressor.
30. PNEUMATIC CIRCUIT
Use tubes, recommended pneumatic tools that withstand a pressure greater than or equal to
the maximum working pressure of the compressor.
31.-If the power cord is damaged, it must be replaced by the manufacturer, his authorised
service agent or qualified personnel in order to avoid danger.
76
Electric compressor installation
Replacement
In the case of repairs, only use original spare parts that are identical to the replaced parts.
Repairs must only be carried out by an authorised service center.
Instrucciones para la conexión a tierra
WARNING: This compressor must be grounded during operation to protect the operator
from electric shock. The single-phase compressor is provided with a two-wire plus
ground line. It is recommended never to disassemble the compressor or make any other
connections to the pressure switch. Any repairs should only be carried out by authorized
service centers or other qualified centers. Always remember that the ground wire is green or
yellow/green. Never connect this green wire to an unprotected terminal. Before changing the
power cord plug, be sure to connect the ground wire. If in doubt, contact a qualified
electrician and have the grounding checked.
Use of extensions
Only use extensions with a plug and ground connection; do not use damaged or crushed
extensions. Make sure the extension is in good condition. When using a cable extension,
ensure that the cable cross-section is sufficient to carry the current absorbed by the machine
to be connected. A very thin extension can lead to voltage drops, resulting in high current
consumption and excessive overheating of the machine. The cable extension of single-phase
compressors must have a section that is commensurate with their length. See table 1.
Table 1: Recommended section for extensions with a
220 V~/230 V~ 110 V~/120 V~
maximum length of 20 m for compressors with working
(mm2) (mm2)
power up to 2 HP /1.5 kW (single-phase). Model: Euro 6
/ Euro 225 / Euro 250 /AB 100-248 M
17
77