Product Specifications - Home2O H70K-51D-ORB Manual De Instrucciones

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 1.8 GPM (6.814 LPM) at 60 PSI
ASME A112.18.1/CSA B125
NSF 61-9
Polished chrome, brushed nickel or oil rubbed bronze finish
ASSEMBLY INSTRUCTIONS
1. Turn off water at the supply valve
under the sink or at the main water
supply, disconnect the supply line,
and remove old faucet.
Clean and dry surface area where
new faucet will be mounted.
2. Before installation, remove the quick
connector (1) from the free end of
the hose (2) by unscrewing it in a
counterclockwise direction. Unscrew
the locking nut (3) and remove the
metal washer (4).
Optional Flange Installation:
3.
Install faucet with attached flange
(5). Retract the hose (1) up through
the faucet body assembly (6) until
the end of the hose (1) is flush with
the bottom of the shank (2). Do not
pull the end of the hose (1) past the
shank (2). Insert the faucet body
assembly (6) through the hole in the
sink (3). Once this step is complete
continue to step 6.
NOTE: Do not feed the hose (1)
back down through the spout (4)
until step 7.
4. Install the metal washer (1) onto the
threaded shank (2). Thread the lock-
ing nut (3) onto the shank (2). Lock
the locking nut (3) into position by
tightening the hex bolts (4). Do not
overtighten.
www.homewerksww.com
1
2
4
3
2
1
3
4
1
6
5
2
3
4
2
4
1
3
Ceramic cartridges
Manufactured to include no more than 0.25% weighted average lead content
on wetted surfaces
Total weight of item: 3.90 lbs.
5. After inserting the hose (1)
through the hole in the sink
surface retract the hose (1) back
down, and reattach the quick
connetor (2) by screwing it into
the end of the hose (3) in a
clockwise motion. Hand tighten
only.
6. Push the quick connector (1)
firmly upward and attach it to the
receiving block (2). Pull down
moderately to ensure the
connection has been made. If it is
necessary to remove the quick
connector (1), squeeze the tabs
on the hose (3) and then pull
down to disconnect. After
connecting the hose (3), install the
weight (4) at the point of the hose
marked "weight here" (5).
Connecting Water Supply
7.
Lines:
(1) Use 1/2 in. IPS faucet supply lines
or (2) use coupling nuts (not
supplied) with (3) ball-nose risers
(not included).
Turn water supply or shut-off valve
back on and check for leaks. If leaks
occur, gently tighten the faucet
connections.
IMPORTANT: Pull the hose
8.
assembly out of the spout and
remove the spray head by
unscrewing it from the hose
assembly in a couterclockwise
direction. Be sure to hold the end
of the hose assembly down into
the sink and turn the faucet on to
the warm position where it mixes
the hot and cold water. Flush line
for one minute. Check for leaks.
Re-tighten any connections if
necessary, but do not overtighten.
Reinstall the spray head by hand
tightening it back onto the hose
assembly.
NOTE: Do not lose the gaskets
in the hose.
2
SPECIFICATIONS
5
2
3
1
6
5
Weight
here
4
4
7
8
2
1
3