Wren V5BT14 Guía De Preparación página 11

Figure 5
Problem connecting? Visit wrensound.com/support for additional help.
To clear the V5BT's memory
of all paired devices, press and
hold the Setup button on the
rear of your V5BT and, while
holding the Setup button, press
the Power button on the front
control panel. The Volume
indicator will blink amber
two times to indicate that the
memory has been cleared. When
the V5BT is powered on again,
it will be in pairing mode and
ready to pair with a Bluetooth
device (see "Pairing with your
V5BT" on pages 8-9).
solid
Note: After you have cleared your
blue
V5BT's memory, you must delete
the Wren speaker from your source
device's list of available Bluetooth
devices before you can pair it
with the V5BT again. To delete
a previously paired Wren V5BT
from your source device's memory,
follow the directions provided by
the manufacturer.
11