Wren V5BT14 Guía De Preparación página 16

Setup
Once you have two Wren V5BT speakers, TrueWireless Stereo setup is easy.
Just follow the steps on the pages 15-17:
If you have previously paired your
device with either speaker, we
recommend un-pairing your device
from the speakers by selecting "Forget
this Device" or "Drop Device" on your
source device's Bluetooth menu.
Place the V5BT speakers as you would
a stereo pair. Ideally, the speakers
should be about as far apart from
each other as the listening area will
be from each speaker, as in the
illustration on the following page.
Connect each speaker to a power
outlet and turn power on.
On the right speaker, simultaneously
press the Source button and the Volume
Up (+) button. The Bluetooth indicator
will begin flashing blue.
16
On the left speaker, simultaneously
press the Source button and the
Volume Down (-) button. The Bluetooth
indicator will begin flashing blue.
The right and left speaker will connect
to each other; this may take up to
15 seconds. When the speakers are
connected the Aux indicators on both
speakers will turn solid white and the
left speaker's Bluetooth indicator
with be solid blue. The right speaker's
Bluetooth indicator should be blinking
amber, indicating the system is ready
to pair to your source device.
In the Bluetooth control section of
your source device, select "discovery"
mode. The right speaker's ID, "Wren
V5BT14_xxxxxx," should appear on
the list of devices that can be paired.