Wren V5BT14 Guía De Preparación página 8

Pairing with your V5BT
Pairing occurs when two Bluetooth devices "communicate" with each other and create a
connection. The Wren V5BT can "remember" the last six Bluetooth devices that have
paired with it. For best results, have your Bluetooth source device near your V5BT.
Note: Your V5BT will automatically enter pairing mode the first time you plug it in. The following
directions are for all subsequent pairings. If you are setting up the speaker for the first time, start
with step 3 below.
Make sure your Bluetooth source
device and the V5BT are both
turned on and the Bluetooth
mode is selected as the source
on your V5BT.
Press the setup button on the
rear of your V5BT
the Bluetooth source indicator
blinks amber once every second
. This will place the
(Figure 2)
V5BT into "discoverable"
mode.
8
until
(Figure 1)
In the Bluetooth control section
of your source device, place the
source device into "discovery"
mode. V5BT14_xxxxxx should
appear on the list of devices that
can be paired.
Figure 1 Figure 2
blinking
amber