Connecting The Hoses - Home Depot PEGASUS 67416-3C01 Guía De Uso Y Mantenimiento

Installation (continued)
4
Removing the protective caps
□
Remove the protective caps (P). Loosen the
anges (Q) from the valve bodys (R & S). Adjust
the rubber washers (T), metal washers (U) and
mounting nuts (V) to the bottom of valve
bodys (R & S).
P
Q
R
T
U
V
6

Connecting the hoses

□
Connect the hoses (W) to the bottom of the hot
and cold end valves (R & S), as shown.
□
Align the middle body (G) in a position that will
allow maximum clearance to connect the
hoses (W).
□
Carefully bend the hoses (W) to t in the
available space, and carefully thread the hose
(W) couplings onto the sides of the middle
body (G). Tighten all connections with a wrench.
P
Q
S
T
U
V
5
Installing the valve bodies
□
From underneath the deck, insert the cold end
valve (S) with the rubber washer (T), metal
washer (U) and mounting nut (V) through
the hole on the right (cold) side.
□
From above, thread the ange (Q) onto the
valve body (S).
□
Tighten the mounting nut (V) using a basin
wrench, so that the ange (Q) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (R)
on the left (hot) side.
R
R
5
Please contact 1-877-580-5682 for further assistance.
Q
S
T
U
V
G
S
W
W
WWW.HOMEDEPOT.COM/PEGASUS