Graham Field LUMEX 7921RA Manual De Instrucciones página 3

OPERATION
Adjusting Leg Height
Push in the leg height adjustment lock button and move
leg extension to the desired height position — you
will hear it click into place. Ensure that all four legs
are locked into place at the same height and all leg
height adjustment lock buttons protrude fully through
adjustment holes.
WARNING: Ensure all Bath Seat components are
secure before each use.
Center of Balance During Use
The point where the Bath Seat will tip forward,
rearward or sideward is determined by its center of
balance and stability, and the center of balance and
stability is affected by the user's body position and
weight distribution. If you fail to heed the following
warnings, falling or tipping may occur and could cause
severe personal injury.
WARNING: To avoid falling or tipping:
Have someone help you until you know the
balance points of your Bath Seat and how to avoid
tipping.
Do not put downward weight on one armrest at a
time. If using the armrest for balance, hold both
armrests at once to distribute your weight equally.
Do not put downward weight on the backrest.
Do not reach or lean if you must shift your weight
to do so. Ask for help or use a device to extend
your reach.
Never try to reach an object if you must move
forward in your seat and your buttocks do not
stay in full contact with the seat.
Never lean backward to reach an object.
MAINTENANCE
WARNING: Check the Bath Seat weekly for signs of damage or cracking. If damage or
cracking of any component of the Bath Seat is found, DO NOT use the Bath Seat. Contact
your Graham-Field authorized provider.
To clean the Bath Seat, wash it with soap and water or a mild detergent, then rinse. Ensure the
Bath Seat is rinsed well before use.
7921RA-INS-LAB-RevC19
7921RA Bath Seat
with Arms and Backrest
Shown Assembled
7931RA Bath Seat with Arms
Shown Assembled
3