Product Description; Safety Rules; Installation; How To Install The Camera - Avigilon ES-HD-HWS-SM Manual De Instrucciones

1 Product description

The ES-HD-HWS-SM has been designed to
optimally fit into small spaces. The side opening
system allows easy access to the camera and lens.

1.1 Safety rules

The manufacturer declines all
responsibility for any damage caused
by an improper use of the appliances
mentioned in this manual. Furthermore,
the manufacturer riserve the right to
modify its contents without any prior
notice.
• The device must be installed only and
exclusively by qualified technical personnel.
• Before any technical work on the appliance,
disconnect the power supply.
• Do not use power supply cables that seem worn
or old.
• Never, under any circumstances, make any
changes or connections that are not shown in
this handbook: improper use of the appliance
can cause serious hazards, risking the safety of
personnel and of the installation.
• Use only original spare parts. Not original spare
parts could cause fire, electrical discharge or
other hazards.
• This device was designed to be permanently
installed on a building or on a suitable structure.
• When installing the device, comply with all the
national standards.
• The electrical system of the building on which
the device is to be installed must have a two-
pole protection circuit (circuit breaker) complete
with an automatic two-pole switch which
provides protection for earth fault current (circuit
breaker + differential) with a minimum distance
between contacts of 3mm.
• Any device which could be installed inside the
housing must comply with the current standards.
ES-HD-HWS-SM

2 Installation

2.1 How to install the camera

1. To open the housing, loosen
the 2 screws on the side (01).
01
2. Fasten the camera ith the 1/4" screw
(01) to the camera support (02) and, if
necessary, place the insulating spacer
between the camera and support (03).
01
3. Fasten the camera support
using the 2 screws.
03
02
3