Clarke Focus II Disc 26 Manual De Instrucciones página 20

ENGLISH
EN
HOW TO OPERATE THE MACHINE
How To Clean A Floor
WARNING: Water solutions or cleaning materials
used with this type of machine can leave
wet areas on the floor surfaces. These
areas can cause a dangerous condition
for the operator or other persons. Always
put CAUTION signs near the area you are
cleaning.
To clean a floor follow this procedure:
1. Set the parking brake (if equipped with machine.)
2. Put the water and a cleaning chemical in the clean
solution tank.
3. Release the parking brake (if equipped with machine.)
4. Turn the key switch "ON".
5. Lower the squeegee.
6. Press the one touch control button to lower the brush
head assembly and start vacuum motor.
7. Adjust the flow of clean solution to the flow desired.
8. Move the machine across the floor in the forward
direction.
9. Make a 180° turn.
NOTE: When you make more passes across the floor, let the
brush clean approximately 2 inches (5 cm) of the area already
cleaned by the brush.
NOTE: During most cleaning procedures, apply and remove
the solution in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty floor, follow this procedure:
1. Apply solution to the floor.
2. Do not lower the squeegee. Shut vacuum motor "OFF".
3. Lower the brush or pad and scrub the floor.
4. Scrub the floor again with additional solution and lower
the squeegee and turn vacuum motor "ON".
5. Pick up all the solution with the squeegee.
-20-
®
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER ®