Nolan N104 ABSOLUTE Seguridad E Instrucciones página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
WARNING!!!
-
The protection level of this helmet whilst riding depends upon the configu-
ration adopted by the user: total protection if the chin guard and visor are
closed, partial protection if the chin guard and/or visor are open.
-
Do not remove nor tamper with the fixing screws that connect the chin guard
to the shell.
-
Do not use the helmet without the chin guard.
-
Do not use the helmet in case of faulty chin guard. Contact immediately a
Nolan authorized dealer.
VISOR MECHANISM SYSTEM
1
VISOR DISASSEMBLY
1.1 Open the visor completely with the chin guard closed.
1.2 Press and hold the visor release button (A) towards the front of the helmet and
release the rear inner visor fastening (B) from its seat by pulling the visor outwards.
1.3 Let the visor slide forwards until the front inner fastening (C) releases from the
mechanism (Fig. 4).
1.4 Repeat the same steps on the other side of the helmet.
Warning: Do not remove the visor's opening and closing mechanisms from the
chin guard.
2
ASSEMBLY
2.1 With the chin guard closed, set the visor in open position by placing the inner visor
fastenings (B) and (C) into their seats in the visor mechanism (Fig. 4).
2.2 Insert the fastening (C) in the provided front seat and press the visor against the
side mechanism in line with the rear fastening (B).
2.3 At the same time push the visor release button (A) towards the front of the helmet
until you hear the fastening click of the visor to the mechanism.
2.5 Repeat the same steps on the other side of the helmet.
WARNING!
-
Make sure that the system is working properly. Open the visor. By lifting the
chin guard, the visor closes automatically.
-
Do not use the helmet if the visor has not been assembled properly.
-
If the visor opening/closing mechanisms are not working properly or if such
mechanisms get damaged, please contact a Nolan authorized dealer.
(Available as an optional accessory)
1
PINLOCK
INNER VISOR ASSEMBLY
®
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin ad-
justment external levers are turned inwards.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido