TRAPP WM-350 Manual De Instrucciones página 32

Assemble as shown in the pictures:
✔
Start by attaching the 3 rear clamps (Fig 1)
and so on for both sides.
✔
For proper operation of the WM-350 lawn
mower, use the grass catcher.
1
✔
Unplug the lawn mower.
✔
Attach the blade as shown in the picture:
Note:
If necessary to use a cutting height lower
than the one allowed by the lawn mower
adjustment system, use the support
washers as shown the picture.
Note:
To check the balance of the blade, place a
round tube over the blade hole to check
whether the blade is balanced (as in the
picture beside). If it is not, balance it by
sharpening the cutting area until the
removal of material reestablishes the
balance of the blade.
30
Assembly of Grass Catcher
2
Blade Attaching Set
Blade Balancing
3
4
Support
Washer