Restoring To Factory Defaults And Resetting; Led Indicator - Zipy GO EarAir Guía De Usuario

3) Manual connecting to last connected A2DP device
When the headset is in standby mode and doesn't connect to any A2DP
devices, move Switch One to
connected A2DP device automatically.
Notes:
Before connecting to a Bluetooth device, please turn on the Bluetooth
device's Bluetooth function.
On some Bluetooth devices, take some Nokia mobile phones for example,
you have to allow automatic connecting in the mobile phone's settings.
Please refer to your mobile phone's manual for further information.

7. Restoring to factory defaults and resetting

Make sure the headset is off, press and hold
simultaneously for about 8 seconds, release them when you hear two "DU"
tones and see red and blue LEDs are on, now the headset restores to factory
defaults, and the pairing information will be deleted.
Charge the headset to make it reset.

8. LED indicator

1) Charging
LED indicator
Red LED is on
Red LED is off
2) Pairing with the Bluetooth devices
LED Indicator
Red and blue LED blink alternately
Blue LED blinks once quickly every
2 seconds
Blue LED blinks twice quickly every
4 seconds
Blue LED blinks three times quickly
every 4 second
Blue LED gradually turns on and off
Red LED blinks twice every 20
seconds
(next song) button, it will connect to last
Status of the headset
Charging
Finish charging
Status of the headset
Pairing mode
Not connected to a device
Set up HFP or A2DP
connection
Set up HFP and A2DP
connection
Conversation mode
Low power
10
and buttons