Kohler Provence K-14513 Manual Del Usuario página 4

Lavatory
Screw
Link
Gasket
Nut
Nut
Spring
Clip
Body Washer
Rod
Seal
Tailpiece
Style A
2. Drain Installation
- Refer to the illustrations above to determine drain style. Please
follow the appropriate instructions, based on your drain.
3. Drain Installation–Style A
- Disassemble the drain components.
- Remove the protective material from the flange.
- Wrap the bottom 2/3 of the flange threads with 3 layers of sealant
tape.
- Apply a ring of plumbers putty or other sealant to the underside of
the flange according to putty manufacturer's instructions. Insert the
flange into the lavatory drain hole.
- Assemble the gasket (tapered side up) and washer to the flange and
partially thread the nut to the flange. Do not fully tighten the nut at
this time.
- Install the body washer and body with the seal hole facing the back
of the lavatory and tighten.
- Ensure the seal hole is facing the back of the lavatory and fully
tighten the nut using care to avoid scratching the finish.
A
1015485-2-
Seal
Stopper
Flange
Apply
Plumbers
Putty
Apply 3 layers
of sealant tape
to bottom 2/3
Washer
Drain Body
Apply 3 layers of
sealant tape and
a small bead of
pipe sealant
4
Style B
Refer to page 6
Kohler Co.