NSK S-MAX pico Manual De Instrucciones página 7

3. Maintenances
3-1 Cleaning ( Clean-Head System )
1 ) Half fill a cup with clean water.
2 ) Brush off the debris at the Clean Head Holes. Do not use a wire brush. (Fig. 2)
3 ) Rotate the handpiece and immerse half of the handpiece head. ( Fig. 3 )
4 ) Rotate and stop intermittently the handpiece about 2 to 3 seconds. ( About 3 times )
5 ) By the function of the clean head system, the clean head hole can be washed.
6 ) Stop the handpiece and wipe it dry. If the dirt could not remove from the hole, remove the cartridge
and clean it by brush.
7 ) Perform lubrication and sterilization. ( 3-5 Lubrication and Sterilization )
CAUTION
Use only clean water to maintain the Clean Head System.
Clean Head Hole
Clean Head Hole Clean Head Hole
Fig. 2
Fig. 3
5