Frequency Band Selection - Midland Alan 42 DS Manual De Instrucciones

Ocultar thumbs Ver también para Alan 42 DS:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
Recharge of the batteries
The battery recharge can be possible only by using the NiMH rechargeable battery
case.
Do not try to charge alkaline batteries or non rechargeable batteries. Make sure that
when you charge the radio, only rechargeable NI-MH batteries should be contained
in the battery compartment!
Use a socket ready accessible for ac/dc adaptor; Connect the socket of the wall
adaptor to a mains power socket and insert the jack of the wall adaptor into the
charge jack of the battery case.
When charging is complete detach the socket of the wall adaptor from the mains.
To obtain the maximum performance and capacity, at the first use of the radio, it is
highly recommended to completely discharge/recharge the batteries 2 or 3 times.
Warnings
!
The supplied wall charger is using "standard charging" method. This is a method,
where the charging current is about 10 % of the capacity. Using this method, char-
gers do not automatically disconnect charging when batteries are fully charged.
!
You should avoid to keep the radio permanently connected to the wall charger,
when you do not need it.
!
The charger is only designed for NiMH rechargeable batteries and cannot be used
for standard Alkaline or other not chargeable batteries. Trying to charge such kind
of batteries can be a risk. Such batteries may leak, explode or even burn and cause
damage or personal injuries!
!
Please use only the supplied wall charger type and no other charger.
!
Dispose of the batteries according to the procedures set out by local regulations.
!
Mains plug used shall remain readily operable.
6 |
Alan 42 DS instruction guide
How to operate with your Alan 42 DS
1. Insert the antenna in the antenna connector.
2. Insert the batteries into the battery compartment, noting polarity.
3. Rotate the ON/OFF volume control clockwise to turn the unit on. Adjust the
volume for a normal listening level.
4. Adjust the SQUELCH control
5. Select the desired channel by the UP/DOWN or QUICK UP/QUICK/DOWN
buttons
Note: if the channel does not change,control that the EMG or LOCK button has not
been pressed. In this case, press the EMG or LOCK button to deactivate this function.
As far as the other functions are concerned, refer to previous instructions.
To transmit: press and hold the PTT button, then talk to the microphone.
To receive: simply release the PTT button.
CAUTION: DON'T EXPOSE THE DISPLAY TO EXTREME TEMPERATURES.

Frequency band selection

The frequency bands must be chosen according to the country where you are ope-
rating.
Procedure:
1. Switch off the unit.
2. Turn it on while pushing the "A/F-LCR" and "SC" buttons.
3. By pushing the ▲ and ▼ buttons at the left hand side of the radio, select the
desired frequency band (see the chart).
4. To fix your selection, press the "A/F-LCR" button.
NOTE
: If you select a frequency band which operates in FM mode only, the "A/F-
1
LCR" control activates the LCR function (Last Channel Recall).
NOTE
: In the UK frequency band, you can select directly the I (Italy) band by pushing
2
the "AM/FM" button for 2 seconds.
Alan 42 DS instruction guide
| 7

Publicidad

Tabla de contenido
loading

Tabla de contenido