Important Spares - Braun favorita II Instrucciones De Manejo

The cutter head can cut properly only if there are no
hairs between the cutter blades.
Tighten the knurled screw only so far that the upper
cutter blade can still be moved with moderate pres-
sure from the side.
Cutter heads are changed while the machine is run-
ning. To do this, the lever on the side of the ma-
chine must be pressed.
To maintain the accuracy of cutting over a longer
period, a heavily soiled coat of the animal to be
sheared should be cleaned beforehand.
To ensure trouble-free cutting, it is advisable to
comb the animal thoroughly and to untangle mat-
ted parts.
The cutter heads can be professionally sharpened
several times. For this purpose, contact an
authorized repair shop:
Aesculap Suhl GmbH
Fröhliche-Mann-Straße 15
98528 Suhl / Germany
Phone: +49 3681 49820
Fax: +49 3681 498234
E-mail: suhl@aesculap.de
www.aesculap-schermaschinen.de
5. Storing
Keep the clipper in a dry place with oiled cutter heads
and cutter head holder.
6
6.

Important spares

When ordering spare parts please indicate the serial
number as well as the type of the clipper 20 (Fig. 1) to-
gether with the cataloque number of the spare re-
quired.
GT 604 Special oil for cutter heads
GT 605 Special gear grease
GT 104 614 Carbon 24
GT 104 803 Airfilter 4 (Favorita/Elektra)
GT 104 808 Oscillating lever 22
GT 104 244 Plastic sliding bar 23
GH 214 813 Airfilter 4 (EHMANN)
TA 004 662 Knurled screw 11
TA 004 663 Cylinder screw 14 for fixing pres-
sure plate 15 at the lower cutter
blade
GT 730 203 Plate spring 12
GT 730 201 Pressure plate of plastic 15