Home Decorators Collection 51662 Guía De Uso Y Cuidado página 8

Assembly - Close-To-Ceiling Mount
1
Close-to-Ceiling Mounting
□
Remove the canopy ring (K) from the canopy (C) by turning the
ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (LL) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (JJ) in the round
holes. This will enable you to remove the mounting bracket (A).
□
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three studs.
LL
2
Routing the wires
□
Remove three of the six screws and lock washers (FF) (every
other one) securing the motor collar (M) to the top of the fan
motor housing (D).
□
Route the wires exiting the top of the fan-motor assembly
(D) through the rubber gasket (BB) aligning the holes in the
rubber gasket (BB) with the three screw holes in the fan-
motor assembly (D).
□
Route the wires exiting the top of the fan-motor assembly (D)
through the canopy ring (K), and the canopy (C) (make sure
the slot openings for the canopy ring and canopy are on top).
Place the canopy (C) over the collar (M) at the top of the motor
assembly (D).
□
Align the mounting holes with the holes in the motor (D) and
A fasten, using the three screws and lock-washers (FF) removed
previously. Tighten the mounting screws securely.
JJ
C
L
K
FF
8
FF
C
BB
M
D