Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
GB
OPERATION
●
The medallion enables elderly or disabled people to trigger the
sirens or telephone dialer or to cause emission of beeps by the
control panel in the event of attack or faintness simply by pressing
the main push button for more than two seconds or pulling on the
sliding part of the medallion. The medallion can be activated
24 hours a day whether the alarm system is on or off.
This detector is only compatible with Dual Frequency control
panels.
CHARACTERISTICS
●
Dual Frequency radio transmission
●
Lithium battery power supply
●
10 years minimum autonomy under normal operating conditions
●
Red light indicates emission, battery state OK and programming
error
●
Customised installation radio code
●
You can choose from the Alert Call, Silent Alarm or Audible Signal
channels
●
Channel emission every 15 minutes if the medallion remains ope-
ned after triggering
IMPLEMENTATION
FIG. A
Front view
➀ Cover
➁ Base
➂ Sliding part
➃ Main push button
➄ Light indicator
➅ Cord
FIG. B
Opening
❶ Slide the cover on the base.
❷ Remove the sliding part from its rail.
Warning: do not use any tools to open the medallion, as this may
cause damages to the mechanical parts.
FIG. C
Inside view
➀ "0" push button for customisation.
➁ "1" push button for customisation.
➂ Light indicator.
➃ Batteries.
FIG. E
Installation radio coding
The installation radio code is programmed by pressing the "0" and
"1" push buttons. The control panel and telephone dialer must be
coded beforehand.
12
●
On the first line, mark the boxes corresponding to the installation
radio code for the control panel (a cross for each opened hole). On
the second line, below each cross, mark a 0. In each empty box,
mark a 1.
1
installation radio code
medallion code
Example (not to be used): you have broken the connections 2, 7
and 8 on the control panel .
1
installation radio code
medallion code
1
Caution: For telephone dialers interface with a 10 microswitch bar
for the installation radio code, fill in the 10 boxes on the second line
directly:
❍
with a 1 for a microswitch
in the ON position
❍
with a 0 for a microswitch
in the OFF position
Example (not to be used):
1
installation radio code
medallion code
1
You now have a series of ten 0 (press the "0" push button) and 1
(press the "1" push button) for programming the installation radio
code.
2
3
4
5
6
7
8
2
3
4
5
6
7
8
X
X
X
0
1
1
1
1
0
0
O
N
1
O
N
1
O
N
1 2 3 4 5 6 7 8
9 10
1 0 1 1 1 1 0 0 1 1
2
3
4
5
6
7
8
0
1
1
1
1
0
0
GB
9
10
9
10
1
1
9
10
1
1
13
Publicidad
Tabla de contenido
