Activating Live Mode; Night Exposures - Kompernaß WK 8 B3 Instrucciones De Uso

Activating live mode

The standard operating mode of the camera is live mode. This mode
is used to take pictures using the motion sensor 5. To set live mode,
slide the operating mode selector switch z to the position "ON".
After 15 seconds, the red LED on the LED display 2 will go out,
after which the camera will start working autonomously and switches
to standby mode. As soon as any wild animals or similar enter the
detection range of the motion sensor, the camera will start capturing
photos and/or videos (depending on the configuration).
When the wild animals leave the detection range of the motion
sensor, the camera switches off and goes back into standby mode.

Night exposures

During night exposures the infrared LEDs 1 on the front of the
camera provide the required light for making recordings possible.
The LEDs emit light over a wide angle. This makes it possible to make
night recordings at a distance of about 3 m to 20 m without overex-
posing the subject. However, reflective objects such as traffic signs
can cause overexposure if they are located within the recording range.
Please note that night exposures are made in black and white.
GB │ IE │ 37 ■
WK 8 B3