TABLE FAN
9
•THE CLEANING MUST NOT BE CARRIED OUT BY UNSUPERVISED
CHILDREN.
RISK OF ELECTRICAL BURNS!
•THIS APPLIANCE IS DESIGNED TO OPERATE ONLY WITH ALTERNATING
CURRENT. BEFORE OPERATING, MAKE SURE THAT THE VOLTAGE
CORRESPONDS TO THE ONE INDICATED ON THE DATA PLATE.
•ONLY CONNECT THE APPLIANCE TO THE POWER OUTLETS WITH A
MINIMUM CAPACITY OF 10 AM PERES.
•DO NOT PULL THE POWER CORD OR THE APPLIANCE
ITSELF TO REMOVE THE PLUG FROM THE
WALL SOCKET.
•FULLY UNWIND THE POWER CORD BEFORE OPERATING THE
APPLIANCE.
•USE AN ELECTRIC EXTENSION CORD ONLY IF IT IS IN PERFECT
CONDITION.
•NEVER LET THE POWER CORD RUN THROUGH SHARP EDGES; AVOID
CRUSHING IT.
•DO NOT LEAVE THE APPLIANCE EXPOSED TO ATMOSPHERIC AGENTS
(RAIN, FROST, SUN, ETC.).
•NEVER USE THE APPLIANCE:
-WITH WET OR MOIST HANDS;
-IF IT HAS FALLEN AND HAS OBVIOUS RUPTURES OR MALFUNCTIONS;
-IF THE PLUG OR POWER CORD DEFECTIVE;
-IN HUMID OR GAS SATURATED ENVIRONMENTS.
•DO NOT COVER THE APPLIANCE WITH TOWELS, CLOTHING, ETC.
•PLACE THE APPLIANCE ONLY ON HORIZONTALAND STABLE
SURFACES, AWAY FROM SHOWERS, BATHTUB, SINKS, ETC.
•IF THE APPLIANCE IS WET OF GETS IN CONTACT WITH WATER, DO
NOT USE IT AND HAVE IT
CHECKED BY A SPECIALISED LABORATORY.
•ALWAYS REMOVE THE MAINS PLUG FROM THE POWER SUPPLY
IMMEDIATELY AFTER USE AND BEFORE PERFORMING ANY CLEANING
OR MAINTENANCE WORK.
•REPAIRS SHOULD ONLY BE CARRIED OUT BY A QUALIFIED
TECHNICIAN.
•REPAIRING THE APPLIANCE BY YOURSELF CAN BE EXTREMELY
DANGEROUS.
•AN APPLIANCE THAT IS NOT WORKING ANYMORE, MUST BE
RENDERED UNUSABLE, BY CUTTING THE POWER CORD BEFORE
THROWING IT .
•CLEAN THE APPLIANCE USING A DAMP CLOTH. DO NOT USE