weasy LIN220 Manual De Instrucciones página 7

C E
1. Cleaning tips
4. Automatic power failure prompt
Suggestions before using the iron for the first time
1. Certain parts of the iron have been lightly greased therefore the iron could give off a little
smoke when plugged in for the first time. This will cease after a short while.
2.Before using the iron for the first time , remove the plastic protector from the base (if it has
one) clean the base with a soft cloth.
3. Keep the base very smooth. Do not run it over metal objects (such as against the ironing
board, buttons , zips ,etc.)
4. Pure wool fibres (100% wool)can be ironed with the appliance in the steam position .by
preference ,select a high steam position and use a dry ironing cloth.
Steady temperature
1. Check the ironing instructions on the garment to be ironed.
2. Electronic temperature control, no need to manually adjust temperature
How to fill the water tank.
1. Disconnect iron power supply
2. Open the water cap
3. Fill the water tank to the MAX water level and close the cap
4. If you have hard water ,it is advisable to use only distilled or demineralized water.
-do not use chemically de-limed water or perfumed
Steam ironing
1.Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3.Steam ironing is possible only when heating is complete.Otherwise ,water may escape
through the soleplate.
4. Wait until the indicator does not flicker to prove that the bottom plate has been heated.
5.Press Steam switch to realize Steam ironing。
6.When the iron is finished, place the iron in an upright position or on the base when the iron is
2.No water in the tank.
5.Energy saving steam
3. Big gear steam