weasy LIN220 Manual De Instrucciones página 8

interrupted
7.Disconnect the iron from the mains supply . Pour of any remaining water and leave the iron
to cool off.
Continuous steam
1.Heating completed, temperature stabilized
3.Start steam switch, can choose large steam or ECO steam at the same time, the two stalls
can be switched at any time
Explosion steam
- When the heating is completed, the temperature is stable.
- Press the steam in two seconds quickly, and the steam will start to explode in two seconds,
while the steam will flash for 2 seconds.
Cleaning
1. Please make sure there is enough water in the tank
before cleaning
2.When the pump works for 25 hours, it will prompt the
product to be cleaned.
3.Please put the iron in a safe position before cleaning
to prevent people from being injured by hot water during
cleaning
4.After the heating is complete , the long press the
cleaning switch for 3 seconds , and the iron enters the
cleaning mode .The display on the screen flashes and
goes with the 3 sound of bees.
5.Two minutes later, the buzzer rang three times,
indicating that the cleaning was complete.
Auto shut off
1. When the iron is stationary for more than 10 minutes, the iron goes out of power mode
2. The power-off sign flashed on the display, accompanied by six buzzing sounds
3. Press the steam switch to restore the power
4. Irons will not be cut off during steam discharge
Anti drip
This iron is equipped with a drip stop function: the iron automatically stops steaming when the
temperature is too low to prevent water from dripping out of the soleplate.
Anhydrous detection
In the course of working, if there is no water in the water tank, the pump will automatically stop
working to protect the life of the pump