General Safety Information For Power Tools - Grizzly EHS 600-61 R Traducción Del Manual De Instrucciones Original

UK
Safety class II
Machines are not to be place with
domestic waste.
General Safety Information for
Power Tools
WarnIng! Read all safety informa-
tion and instructions. Failure to
adhere to the safety information and
instructions may result in electric
shock, fire and/or serious
The term „power tool" in the warnings
refers to your mains-operated (corded)
power tool or battery-operated (cordless)
power tool.
Keep all safety information and instruc-
tions for future reference.
Work area safety
• Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
Do not operate power tools in
•
explosive atmospheres, such as in
the presence of flammable Iiquids,
gases or dust. Power tools create
sparks which may ignite the dust or
fumes.
• Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.
Electrical safety
CAUTION! The following states how
to avoid accidents and injuries due
to electric shock:
• Power tool plugs must match the
outlet. Never modify the plug in any
way. Do not use any adapter plugs
100
•
•
injuries..
•
•
•
•
•
Personal safety
with earthed (grounded) power
tools. Unmodified plugs and matching
outlets will reduce risk of electric shock
Avoid body contact with earthed or
grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric
shock if your body is earthed or
grounded.
Do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged or
entangled cords increase the risk of
electric shock.
When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of an RCD
reduces the risk of electric shock.
Where possible, connect the
equipment only to a plug socket with
a leakage-current-operated circuit
breaker (FI switch), with a rated
current of not more than 30 mA.
If the power cable for this equipment
is damaged, it must be replaced
with a special power cable, which is
available from the manufacturer or a
customer service agent of the same.
CAUTION: How to avoid accidents
and injuries: