Residual Risks; Electrical Safety - Black+Decker SVB520JW Traducción De Las Instrucciones Originales

ENGLISH
Regularly check the charger lead for
u
damage. Replace the charger if the
lead is damaged or defective.
Never attempt to remove or replace
u
any parts other than those specified in
this manual.
Additional safety instructions
After use
Unplug the charger before cleaning the
u
charger or charging base.
When not in use, the appliance should
u
be stored in a dry place.
Children should not have access to
u
stored appliances.

Residual risks

Additional residual risks may arise when
using the tool which may not be included
in the enclosed safety warnings. These
risks can arise from misuse, prolonged
use etc. Even with the application of
the relevant safety regulations and the
implementation of safety devices, certain
residual risks can not be avoided. These
include:
Injuries caused by touching any
u
rotating/moving parts.
Injuries caused when changing any
u
parts, blades or accessories.
Injuries caused by prolonged use
u
of a tool. When using any tool for
prolonged periods ensure you take
regular breaks.
Impairment of hearing.
u
Health hazards caused by breathing
u
dust developed when using your
tool (example:- working with wood,
especially oak, beech and MDF.)
6
(Original instructions)
Chargers
Your charger has been designed for a
specific voltage. Always check that the
mains voltage corresponds to the voltage
on the rating plate.
Warning! Never attempt to replace the
charger unit with a regular mains plug.
Use your BLACK+DECKER charger
u
only to charge the battery in the
appliance with which it was supplied.
Other batteries could burst, causing
personal injury and damage.
Never attempt to charge non-
u
rechargeable batteries.
If the supply cord is damaged, it must
u
be replaced by the manufacturer or an
authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The appliance/battery must be
u
placed in a well ventilated area when
charging.

Electrical safety

Symbols on the charger
Read all of this manual carefully before using the
#
appliance.
This tool is double insulated; therefore no earth wire
$
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
The charging base is intended for indoor use only.
Labels on appliance
The following symbols appear on this appliance along with the
date code
Read all of this manual carefully before using
the appliance