Beurer JBY 86 Instrucciones Para El Uso página 18

• The charging process lasts for approx.
10 hours when the device is switched
off.
Note
Preparing the device for first use
• Before the first use, the batteries should
be fully charged. The charging process
lasts for approx. 10 hours. The device
offers an operation period of approx.
16 / 22 hours after this.
• You will get the maximum capacity from
your battery if you charge it at least once
every 6 months. To do this, disconnect
the device from the mains and run the
battery down through normal use. Then
fully charge the battery up again.
• The maximum battery capacity can only
be reached after it has been charged
several times and is dependent on many
factors (battery state, ambient tempera-
ture, means and frequency of charg-
ing etc.).
Note
Observe the battery level indicator in the
display and replace the batteries in good
time.
Mains operation
Using the adapter plug, connect the units
to a socket.
6. Operation
• Position the transmitter so that it is in a
raised position at a distance of 2 m from
your baby.
• Switch the transmitter on using the on /
off / channel changer and select one of
the two channels.
• The display will begin to light up and the
selected channel is displayed.
• Switch the receiver on by selecting the
same channel as that set on the trans-
mitter. The display will begin to light up
and the selected channel is displayed.
Check the connection between the two
devices – the devices should not be more
than a metre away from each other, or this
may create feedback. If the transmitter
is not transmitting any sound, the symbol
'baby is asleep' appears and the back-
lighting automatically switches to energy
saving mode.
• If the transmitter is transmitting sounds,
the symbols for 'baby is awake' appear
and the backlighting automatically
switches on.
18