1
Empty water reservoir
1.
If the water reservoir is empty, you will hear an alert that the reservoir must be refilled. You will hear
a signal and all indicator lights will flash red. Turn off the appliance.
2.
Fill the water reservoir with the desired amount of water. Make sure if the level is within the 'MIN'
and 'MAX' indicators on the reservoir. The reservoir is removable. Take the reservoir out of the unit.
Open the lid, fill the water reservoir, and carefully place it back in the appliance. Turn the appliance
back on.
SETTINGS
There are different ways to set the unit to your likings. We recommend that you first try the unit with
the factory settings. If these are not to your liking, use the instructions in the instruction manual to
personalise the unit to your liking and align it to the coffee beans you want to use. Besides the settings,
the type and quality of the coffee beans influence the taste and intensity of your espresso.
Adjusting coarseness
There are number markings on the grinder that indicate the coarseness of the ground coffee. There are 15
settings. You have to adjust the coarseness while the appliance is grinding. If you rotate it while the unit is
in standby mode, a bean might get into the grinder and stop it.
First, try the coarseness at position 8 and taste the coffee. You can then adjust the coarseness based on
this taste. A grinding coarseness that is too fine gives the coffee a bitter taste. If it is too coarse, the coffee
will be weak and watery.
The finest grind is indicated by 1. The coarsest grind is indicated by 15.
Setting grinder volume
You can set the grind time to your personal preference. The standard setting is 14 seconds. The amount of
ground coffee you make depends on the type of bean and the coarseness setting.
46
DO725K
2
3
5
OR
6
4
7