Switch On And Off - Flex LW 1503 S Instrucciones De Funcionamiento Originales

Wet stone grinder
 Hold the spindle with the enclosed
wrench (1.).
 Screw tool holder (Velcro or support pad)
onto the spindle (2.).
 Attach grinding tool to tool holder.
Function test:
 Insert the mains plug into the socket.
 Switch on the grinder (without locking
the button) and leave it running for approx.
30 seconds. Check for imbalances and
vibrations.
 Switch off the grinder.

Switch on and off

LW 1503/~S, LW 1703/~S
Brief operation without engaged
switch rocker:
 Push the switch rocker forwards and hold
in position.
 To switch off the power tool, release
the switch rocker.
Continuous operation with engaged
switch rocker:
`^rqflk>
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇJçå=
ã~ÅÜáåÉ=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 Push the switch rocker forwards and
engage by pressing the front end.
 To switch off the power tool, release the
switch rocker by pressing the rear end.
Switch on and off
LW 1202/~S, LW 802 VR/~S
Brief operation without engaged
switch rocker:
 Press and hold down the starting lockout.
 Press the switch and release the switch
interlock.
 To switch off, release the switch.
Continuous operation with engaged
switch rocker:
`^rqflk>
cçääçïáåÖ=~=éçïÉê=Ñ~áäìêÉI=íÜÉ=ëïáíÅÜÉÇJçå=
ã~ÅÜáåÉ=ïáää=ëí~êí=êìååáåÖ=~Ö~áåK
 First press and hold down the starting
lockout and then the switch.
 To lock into position, hold down the locking
button and release the switch.
Release the starting lockout.
 To switch off, briefly press and release
the switch.
Speed preselection
(LW 802 VR/~S only)
To set the operating speed, move the dial to
the required value.
Setting
1
2
3
4
5
6
Operating instructions
klqb
tÜÉå=íÜÉ=ëíçåÉ=ÖêáåÇÉê=áë=ëïáíÅÜÉÇ=çÑÑI=
íÜÉ ÖêáåÇáåÖ=íççä=ÅçåíáåìÉë=êìååáåÖ=ÄêáÉÑäóK
 Attach sanding tool.
 Connect machine to the power supply.
 Connect the water.
 If required, adjust speed to the task
(LW 802 VR/~S only).
 Switch on the machine.
 Open shut-off valve on the water connection.
 Applying light pressure, place the grinding
tool on the material to be processed.
Excessive pressure will increase the wear
on the grinding tool and impair the grinding
result.
–1
Speed (min )
800
1100
1400
1700
2000
2400
19