DeLonghi GM6000 Instrucciones De Uso página 5

Important:
• This appliance must not be laid on its side or turned upside down.
• Wait at least 1 hour after transporting the appliance before starting it.
• Do not leave the selector in the
• After the appliance have been shut off, always wait at least 5 minutes before starting it again.
• Use the appliance away from heat sources. Leave at least 8 in (20cm) between the appliance and walls or
objects which could obstruct free air circulation.
• Do not remove the lid while the paddle is moving.
• Make sure ingredients such as milk and cream are cold (refrigerator temperature 41°F/5°C). If ingredients
were heated during preparation make sure they are cooled in the refrigerator before pouring into the
machine.
• When raw eggs are to be used for gelato preparation, make sure they are fresh by breaking each egg
separately into a bowl and check that it does not smell bad, the egg white is dense and sticks to the yolk,
and the yolk Is round and swollen.
• IMPORTANT: After turning the appliance off from "
it on again.
DESCRIPTION OF SELECTOR
The selector has 4 different positions:
Paddle rotation (compressor off)
Use this function to mix the ingredients during the first phase of gelato preparation.
• Important: you cannot add ingredients to the bowl while the paddle is in motion.
Appliance off.
Chilling (compressor operating)
This function to add or taste ingredients during preparation or to stop the paddle to check the texture of the gelato.
If the recipe requires ingredients to be added (pieces of chocolate, raisins, fruit...), turn the selector to the
for a maximum of 1 minute.
Important: you must never leave the appliance in this position for more than 1 minute.
Leaving it in this position for longer could seriously damage the paddle rotation mechanism.
Combined paddle rotation and chilling (compressor operating)
This function to make the gelato through the combined action of the compressor and the paddle.
When the gelato reaches the required texture, place the selector in the
each gelato making cycle lasts about30 - 40 minutes.
Continuous functioning beyond this time will result in excessively hard gelato and serious damage to the paddle rota-
tion mechanism.
Important: if you need to work the ingredients with a whisk (e.g., to froth the egg whites, beat the eggs and sugar, etc.),
you are recommended to prepare the ingredients in a separate container and then pour them into the bowl.
Select the function to start making the gelato.
INSTRUCTIONS
ASSEMBLY AND DISSASSEMBLY
The appliance comes assembled in the packaging but should be taken apart for cleaning before use. To take the appliance apart, remove the
lid, then remove the paddle from the pin in the center of the bowl. Then remove the bowl. Wash all parts thoroughly as described below in
Cleaning section and then dry. To reassemble the appliance, insert the bowl and press downwards on the edge with the hands (fig. 1). Insert
the paddle then fit the lid.
position for more than 1 minute.
" or " ", always wait at least 5 minutes before turning
position to turn the appliance off. Normally
position
5