Publicidad
Idiomas disponibles
Idiomas disponibles
CP 0009, CP 0014
To further counteract the risk of ice formation, use
a water separator.
Connecting a water
separator
The length of the air hose between the compressor
and the water separator must be such that the water
vapour is cooled and condenses in the hose before
reaching the water separator.
If the ambient temperature is below 32 °F (0 °C) the
hose must be short enough to prevent the water
from freezing before reaching the water separator.
Lubrication
The lubricant is important for the machine s function
and has a great impact on the service life.
Indications of proper lubrication are the presence of
oil mist in the exhaust air and of slight traces of oil
on the drill or adapter shank. Too much lubrication
can cause starting problems, low power or uneven
performance.
In order to supply the correct volume of oil, the built
in oiler should be checked and filled regularly. In
addition, use of an air line oiler is recommended to
assure a constant and adequate supply of lubricant.
Recommended Lubricant: Rockdrill oil with a
viscosity of 100-150 SUS at 100°F (ISO VG 22–32).
A
CP 0009
Daily before using and after each four hours of
service, remove the plug (A) and saturate the felt
and fill the oil receiver with recommended oil.
CP 0014
Daily before using and after each four hours of
service, remove the plug (B) and fill the oil receiver
with recommended oil.
9800 0547 90c | Original instructions
B
Safety and operating instructions
Insertion tool
CAUTION
Hot working tool
The tip of the working tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
Never touch a hot or sharp working tool.
►
Wait until the working tool has cooled down
►
before carrying out maintenance work.
Selecting the right insertion tool
Selecting the right insertion tool is a precondition
for proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.
WARNING
Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
►
Make sure that the inserted tool is
well-maintained, not worn out and of the proper
size.
Always use a sharp tool in order to work
►
efficiently.
NOTICE
Never cool a hot insertion tool in water,
it can result in brittleness and early failure.
WARNING
Ejected insertion tool
If the tool retainer on the machine is not in a locked
position, the inserted tool can be ejected with force,
which can cause personal injury.
►
Before changing the insertion tool, stop the
machine, switch off the compressed air supply
and bleed the machine by activating the start and
stop device.
13
Publicidad
Capítulos
