Operation; Preparations Before Starting; Start And Stop - Chicago Pneumatic CP 0009 Instrucciones De Seguridad Y De Funcionamiento

CP 0009, CP 0014
Removing the insertion tool
Whenever removing the insertion tool the following
instructions must be observed:
CP 0009
1.
Pull the tool retainer and hold it backwards in
the direction of the arrow, remove at the same
time the insertion tool by pulling it out.
CP 0014
1.
Push the tool retainer upwards in the direction
of the arrow.
2.
Pull the insertion tool out.
3.
Push back the tool retainer.
9800 0547 90c | Original instructions
Safety and operating instructions

Operation

Preparations before starting

Check the equipment
Check that all of the equipment is in good
♦
condition.
Check that the impact surface of the insertion tool
♦
shank is flat, with no signs of wear.
Make sure that the air inlet and exhaust ports are
♦
free from obstructions.
Check that the flushing hole in the drill steel is not
♦
blocked, and that the flushing air flows through
without obstruction.
Ensure that the fittings are tight and leak-proof.
♦
DANGER Whipping air hose
A compressed air hose that comes loose can lash
around and cause personal injury or death
Check that the compressed air hose and the
►
connections are not damaged.
Check that all compressed air connections are
►
properly attached.
Blow out the air hose
♦ Every day before using the drill, blow out the air
hose to clear it of accumulated dirt and moisture.
Fill the lubricator with oil
Check that the chuck and insertion tool shank are
♦
always covered with a film of oil.

Start and stop

WARNING Involuntary start
Involuntary start of the machine may cause injury.
► Keep your hands away from the start and stop
device until you are ready to start the machine.
Learn how the machine is switched off in the event
►
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
15