Built-In Radio Receiver - Dea 202RR Instrucciones De Uso Y Advertencias

Operating instructions and warnings
Confirm by pressing on the OK key for a few seconds! The procedure starts
First operator no.2 will start to close until it reaches the stroke end (or the limit
switch), then operator no. 1 will start to close until it reaches the stroke end (or
the limit switch).
WARNING: in case the ground stop is not detected, press again the OK button, the operator stops.
On the display you will read "----". Motor stroke memorization done!
By pressing on the key the leaf must open, by pressing on the
1
swap the two motor cables. Only if you use limit switches, first position the leaf where you want it to stop in closing and then
adjust the closing cam so that it presses on the limit switch associated to it in that point. Then position the leaf in the opening
position and adjust the opening cam so that it presses on the limit switches associated to it in that point.
WARNING In case of operator without encoder, each time you change the force parameters (P014
and P016) you must repeat the operators run learning. If you do not do this, at first input, the control
panel won't execute any manoeuvre and the display shows for a few second "APPr" to remind you to
repeat the learning. In order to avoid having to do the learning again, always check and in this case
modify the programmed force value while positioning the wing.
8.3 Built-in radio receiver ————————————————
DEA 202RR control board includes a 433,92MHz built-in radio receiver accepting both transmitters with
HCS coding (complete rolling code or just fixed part), and HT12E dip-switch coding.
• The type of coding is selected by programming the working parameter n° 8 "type of coding" (see Table
2 Parameters)
• The receiver memory capacity can contain up to 100 different transmitters.
• When receiving a pulse from the transmitter, depending on your channel selection and linking, the start or
the pedestrian inputs are activated. In fact, by programming one of the working parameters it is possible
to choose, according to one's needs, which key of the memorized transmitters will activate the start input
and which one will activate the pedestrian input (see "4. Channel selection and linking on the transmitter").
• While you memorize each transmitter the display shows a progressive number by which you will be able
to trace and, if necessary, delete each transmitter individually.
Instructions
The control board is ready to receive instructions
Scroll down the parameters until you visualize P004
Confirm! The control board awaits a further confirmation
Confirm by pressing on the OK key for a few seconds! The procedure starts
Done! The transmitters memory has been deleted
Scroll down the parameters until you visualize "----". The control board awaits a
further confirmation
20 Scroll down the parameters until you visualize P005
Confirm! The receiver enters in learning mode
The flashing light is on!
Press on any key of the transmitter
Memorization done! The flashing light goes out for 2 seconds the display
visualizes the number of the transmitter just memorized (es. "r001")
The receiver enters again and automatically in learning mode
The flashing light is on!
Memorize all necessary transmitters
key the leaf must close. If this does not happen, you must
Function
Deletion of all transmitters
Memorization of transmitters
1
Display