Environments; Installation; Troubleshooting - Cooler Master iGreen Power 500W Manual Del Usuario

2.3 Environments

1. Dimension：Standard ATX PS2 150×140×86 mm
2. Operation temperature：5~50℃（Nominal Input Voltage）
3. MTBF：＞400,000 hours
4. Safety：Nemko / TUV / cUL / CE / BSMI / FCC / CCC

3. Installation

1. Switch off the main switch of the power supply and disconnect the power cord.
2. Unscrew and open the side panel of the chassis.
3. Disconnect all power connectors from the motherboard and from peripheral devices such as
case fans, hard drives, CD-ROMs, floppy drives, etc.
4. Replace the power supply.
5. Connect P1 and P2 / P3 connectors to your motherboard.
6. Connect other connectors to your system components.
7. Make sure that all other connectors are also connected.
8. Close the chassis and reattach the case screws.
9. Plug in the power cord and switch on the main switch of the power supply.

4. Troubleshooting

If your system does not turn on after installing the power supply, follow the troubleshooting guide
as listed below:
1. Please make sure the main power is switched on correctly. (The main switch of the power
supply should be switched to "1" or "on".)
2. Please make sure the P1 and P2 / P3 connectors are connected correctly to the motherboard.
3. This power supply does not support –5V for the motherboard for new ATX form factor operation.
Please update the BIOS setting of the motherboard.
4. If the power supply does not work properly, please contact our service center immediately.
User's Manual / English
4