Technical Data; Disposal; Equipment; Packaging - NUK Vapo Rapid Instrucciones De Operación

Ocultar thumbs Ver también para Vapo Rapid:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
Vapo Rapid 09-2014 Seite 18 Mittwoch, 24. September 2014 6:05 18
Fault
The appliance does not
switch on again after use,
indicator light 9 is lit up
6 FIRST CHOICE bottles do
not fit into the appliance
Bottles are very hot after
sterilising
Bottles and accessories show
white marks after sterilising
Steam is flowing out of the
accessory holder
The device will not heat,
even though the base has
cooled down
European Model, with 2-PIN plug
(Article No. 10.251.012):
Voltage:
Power consumption:

8.1 Equipment

The symbol of the crossed-
through wheelie bin means,
within the European Union,
that the product is subject to a
separate waste collection. This
applies to the product and all
accessories marked with this
symbol. Products labelled as such must not
be disposed of with the normal household
waste collections; they must be taken to a
recycling bank for electrical and electronic
equipment. Recycling helps to reduce the
use of raw materials and is eco-friendly.
Cause
Overheat protection is
active
Components not
positioned correctly.
Bottles are sterilised at
above 90 °C
Appliance has limescale
deposits
Appliance has not been
assembled correctly
Bottles and accessories
are not suitably positioned
in holder
Thermal fuse has tripped
or heating element is
defective

7. Technical data

220 - 240 V~/50 Hz
550 Watt

8. Disposal

18
Rectification measure
Wait 15 minutes for the appliance to
cool down.
Place bottles upside down in the bottle
holder and without accessories.
Stack lids in bottle holder and then place
the basket on top
Allow bottles to cool down
Use the tongs supplied
Descale appliance (see "5.2 Descaling"
on page 17)
Assemble appliance correctly (see
"4.2 Sterilisation" on page 16)
Separate the components so that the
appliance seals completely (see
"4.2 Sterilisation" on page 16)
Device needs to be repaired. Contact
our Service Centre (see "9.1 Service
Centres" on page 19).
British Model, with 3-PIN plug
(Article N. 10.749.054):
Voltage:
220 - 240 V~/50 Hz
Power consumption:
550 Watt

8.2 Packaging

When
you
wish
to
packaging, please observe the relevant
environmental regulations for your country.
dispose
of
the

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

10.251.01210.749.054

Tabla de contenido