Shutdown Instructions - Dyna-Glo DGA480BSN Manual Del Usuario

Ocultar thumbs Ver también para DGA480BSN:

Manual de instrucciones (34 páginas)

Contenido

Tabla de contenido

Idiomas disponibles

OPERATING INSTRUCTIONS

LIGHTING THE GRILL

Before first use:

Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important

to clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed

and the control knob in the highest position. This will clean the internal parts by burning off any residue

and odor from the manufacturing process.

If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF

the manual gas shutoff valve and then TURN OFF the control knob.

Do not lean over grill when lighting. Read instructions before lighting.

1. Check that the control knobs are in the

2. Open natural gas shutoff valve.

3. Open lid during lighting.

4. Push igniter down 3 to 4 seconds while turning right side control knob to the

burner should ignite.

If ignition does not take place within 5 seconds, immediately turn the control knob to the

position. Wait 5 minutes and repeat Step 4 above or refer to match lighting instructions below.

5. Repeat Step 4 above to ignite left side burner.

If the burner still does not light, check that the manual gas shutoff valve is open and follow the match

lighting instructions.

LIGHTING THE GRILL WITH A MATCH

1. Insert a match in the end of the match holder that is installed on the inside of the cabinet door.

2. Light the match.

3. Immediately place the lit match through the 0.75 inches (20 mm) hole on the side of the grill body,

nearest the left burner. Make sure the lit match is close to the burner ports.

4. Press in the control knob that operates the left burner and rotate counter-clockwise

position and burner should light immediately.

5. The other main control can now be turned on the

6. Adjust burners to desired cooking settings.