Uline H-1799 Instrucciones De Montaje página 3

Figure 4
Release Lever
Figure 5
Drawer Track
Figure 6
PAGE 3 OF 15
ASSEMBLY CONTINUED
DRAWER ASSEMBLY
1. Remove drawer slides from the outsides of the
drawer. Press the drawer slide release lever to
remove slides completely. (See Figure 4)
2. Attach drawer slides to drawer tracks using 2 small
bolts, washers, lock washers and nuts. Extend drawer
slide completely to attach to track. Insert center bolt
first to align front bolt hole. (See Figure 5)
3. Insert drawer tracks into inside of desk top, aligning
front and back bolt holes. Drawer slides must
face inward. Use 4 large bolts and 4 large nuts to
assemble each drawer track to the desk top.
(See Figure 6)
NOTE: Depending on the side, press release
lever either down or up to remove slides.
NOTE: Lip should face the bottom of desk.
0221 IH-1799