OPERATION
WARNING:
!
Always wear safety eyewear complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before
using as a blower.
WARNING:
!
To reduce the risk of injury to bystanders,
keep them clear of blowing debris.
STORAGE
When vacuuming is complete, your RIDGID Wet/Dry
Vac has convenient storage locations.
ACCESSORY STORAGE (Fig. 10)
1. For Storage: Slide the Extension Wands (J) and the
Utility Nozzle (K) onto the Caster Feet Posts.
2. To Remove Wands and Accessories: Lightly rotate
and pull upward.
CORD STORAGE (Fig. 10)
1. To Store Cord: Wrap Power Cord around the top
Carry Handle / Power Cord Wrap (D) beneath the
Two Tabs.
2. Secure the Power Cord using the Cord Clip on the
Polarized Plug.
HOSE STORAGE (Fig. 10)
1. The Tug-A-Long Positive Locking Hose with
Dual-Flex (I) may be stored around the Powerhead
Assembly (A) and secured into the Two Hose
Storage Clips.
LOCKING ACCESSORIES (Fig. 10)
Your RIDGID Wet/Dry Vac includes Locking Accessories
to prevent the Accessories from falling off when in use.
1. To Connect the Locking Accessories: Align the
Nozzle Ridges of the Accessory with the Locking
Tab of your Extension Wand (J). Press to secure
the Nozzle to the Extension Wand.
2. To Disconnect the Locking Accessories: Twist
the Nozzle and Extension Wand to disengage the
Nozzle Ridges and pull. You may also press the
Locking Tab and pull to disengage.
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings
blocked; keep free of dust, lint, hair or anything
that may reduce air flow.
CAUTION:
Do not operate vacuum while the hose is still
wrapped around the powerhead assembly in the
storage position.
CAUTION:
!
Wear a dust mask if blowing creates dust which
might be inhaled.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac/Blower for extended
time or in a noisy area.
(D)
Power Cord
(I)
Hose
Storage
Clip (2)
(A)
(J)
(K)
Caster Foot
Post (4)
(J)
Locking
Tab
8
Fig. 10
Cord Clip
Nozzle Ridges
(K)