Azbil RX-L80 Serie Instrucciones De Uso página 13

z DIN rail installation
After attaching the DIN rail, pull out the DIN rail locking tab
adequately and then attach the base to the rail. Next, push in
the DIN rail locking tab upward until it clicks into place.
Handling Precautions
•
Install the unit on a vertical surface with the DIN rail
locking tabs at the bottom.
„ Terminal block installation and removal
WARNING
Make sure the power source wired to the terminal block is
turned OFF when working. While power is being supplied,
attaching or detaching a terminal block can result in elec-
tric shock if the operator touches an electrode.
Handling Precautions
•
Do not remove the terminal block other than for work, such as:
•
Wiring done before device settings
•
Maintenance
z Removal method
(1) Slide the lock lever of the terminal block to the left to
unlock the terminal block.
(2) Using the upper part of the terminal block as a fulcrum,
remove the terminal block by pulling it out towards you
from the bottom.
z Installation method
(1) Tilt the terminal block and insert its top into the groove in
the case.
(2) Install by pushing the bottom of the terminal block toward
the case.
(3) Slide the lock lever of the terminal block to the right to
lock the terminal block in place.
Handling Precautions
•
Take care to install terminal blocks A and B correctly. An
electric shock warning sign is attached to terminal block B,
which is for connection of AC power/load.
•
If terminal blocks A and B are not correctly installed, they
cannot be inserted far enough. In that case the terminal lock
lever cannot be slid. If they are inserted with excessive force
in order to slide the lever, damage could result.
„ Installing the main unit onto the base
When attaching or detaching the main unit to/from the
base, make sure that the power is turned off. Work while en-
ergized may result in electric shock if the operator touches
an electrode or internal circuit.
Handling Precautions
•
Use the base and main unit from the same package together
as a pair.
•
In the case of the RX-L90, the information recorded on the
base and the information for the main unit differ, so the
following error will occur.
Eb88 Com.CPU_Data error (1)
Make sure that main unit and base product codes match.
•
First attach the hook on the bottom of the main unit to the
base. Failure to do so might cause damage.
•
Do not attach the base to the device when the power LED is
lit. Doing so might damage the device.
•
An RX-L80 base cannot be used with an RX-L90 main unit.
(1) Attach the hook on the bottom of the main unit to the base.
(2) Insert the top of the main unit until the levers make a click.
Base
(1) Hook
To remove, pull the two top levers towards you while pressing
them.
E4
WARNING
(2) Lever
Main unit