brondell Capella Manual Del Proprietário página 12

PRODUCT INSTALLATION
Step 2: Air Gap Faucet Installation
5. Attach the Escutcheon to the Main Body by inserting the blue
faucet tubing, orange brine input tubing, and black drain tubing
(3 tubes) through the Escutcheon. Slide the Escutcheon all the
way up until connected to the Main Body.
6. Install the faucet on top of the countertop or sink, and feed all
three tubes through the hole to the cabinet below.
7. Slide the large, metal Split Washer around the tubes and metal
shaft against the bottom of the countertop or sink hole. The
open split should be facing against the metal shaft.
8. Install the Spacer with the open-ended hole facing up by
sliding the blue tube through as shown. This will keep the blue
tube separate from the orange and black tubes.
9. Install the small, metal Split Washer, Lock Washer, and Locking
Nut through the blue tube and tighten until the faucet is firmly
in place. The faucet is now installed.
10. Pull the plastic tab out from the Battery Seat to activate the LED
Indicator. The LED light will blink red once then blue once, then
it will be ready for use.
TIP: Depending on the amount of space
underneath your sink, you may need to cut
and shorten some of the tubing based on your
needs. When cutting, use sharp scissors or a
cutting knife for a clean cut. The opening edge
of the tube should be even and clean. If the
opening is frayed or crimped, this may affect the
flow of the water running through the tube.
10
Step 5
Step 6
Step 7
Step 8
Step 9