AGV K-4 Manual Del Usuario página 13

1
3
2
4
3.2) Cap Removal/Installation
To remove the cap, release the 2
press studs at the front (1) and the 2
at the back of the helmet (2) and sli-
de them out of the helmet.
NB Extract the cap only after re-
leasing all the press studs to
avoid damaging them and pre-
vent damage to the fabric parts.
To refit the cap, insert it inside the
helmet and clip the 2 press-studs
at the back (3) and the 2 at the
front (4) into place.
3.3) Throat wind shield removal /
installation
To install the fabric shield, insert the
plastic band in the space in the chin
strap.
To remove the shield, slide it out,
pulling in the direction of the arrow.
11