Operating-Presentation-Interfaces; Operating Principle - Cristec HPOWER 12V/90A Manual Del Usuario

2 OPERATING-PRESENTATION-INTERFACES

O
2.1
PERATING PRINCIPLE
The design of the battery chargers in the HPOWER range is based on a high-frequency split converter that transforms
the AC signal into regulated and filtered DC current. They can operate as a DC power supply.
Once the type of battery and type of charge has been selected, operation of the battery charger is entirely automatic
(unless otherwise specified by the supplier or the manufacturer of the batteries). It can remain connected to the
batteries and does not need to be disconnected when starting up an engine (marine application), because it is
equipped with an integrated separator.
The appliance's output voltage is sufficient to recharge 1, 2 or separate 3 batteries (integrated charge distributor,
separation of batteries). The charger's maximum output is the rated current distributed to each output according to
the connected batteries banks.
Each output can deliver the rated current.
Not all the outputs have to be connected. However, if only one output is used, we recommend interconnecting
outputs +BAT 1, +BAT 2 and +BAT E to one another (optional).
31