Vehicle Information - ANCEL FD700 Manual Del Usuario

3.5 EVAP System Test
This function enables the conditions required to conduct an
evaporative system leak test, but does not actually run the test.
The vehicle manufacturer is responsible to determine the criteria to
automatically stop the test.
Before performing this function, please check the vehicle's service
repair manual to determine the necessary procedures.
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test

Vehicle Information

3.6 Vehicle Information
Choose [Vehicle Information] and it displays as follows：
Diagnostic Menu
Read Codes
Erase Codes
I/M Readiness
Data Stream
Evap System Test
Vehicle Information
EN
Datastream
Fuel system 1 status
Fuel system 2 status
Calculated LOAD Value
Engine Coolant
Temperature
Short Term Fuel Trim-
Bank 1
5/6
6/6
16
OL
OL
0.0%
-31°C
0.0%
1-5/19
Erase System Test
Evaportive system leak test
not supported.
OK ESC
Vehicle Information
Vehice Identification Number (VIN)
LVSFBFAC94F020950
Calibration Identifications(CID)
000007550753
Calibration Venfication Number (CVN)
B5073064
OK ESC